A single Flood Gate provides superior protection than over 50 sandbags yet it weighs less than one! A Flood Gate is also a lot easier to store and is completely reusable.
Clear the entrance of dirt and debris then place gate in doorway. Place the barrier with its face toward the flood threat and as close as possible to your entrance in a solid reveal. Using the supplied wrench expand the barrier horizontally into the side walls.
Hand tighten each of the 4 downward pressure bolts to compact the sleeve along the ground. Use the wrench to tighten ground bolts by only 1 turn or until cover is compressed sufficiently to create a seal along the floor.
Once Flood Gate is installed correctly it can hold back up to 26 inches of water. The entryway remains accessible while Flood Gate is installed. Flood Gate can be used inside or outside and can be used for doors that open in or out.
Seal off entryways from oncoming water
Protect entryways in minutes
Flood Gate is built for fast protection wherever water can enter:
Use it on:
If you need to join multiple units together to create wider protection you will need our Flood Gate Stanchion Set or if you need to join and create a right-angle corner you will need our Flood Gate 3-Way Stanchion Set (both sold separately).
NOTE: The base for the stanchion will need to be installed underground.
Neoprene Cover Replacements
For wider openings
For uneven openings
Holds 4 Stanchions & 6 Flood Gates
